How to tie reinforced mesh?

Reinforced mesh has the advantages of firm welding points, reasonable structure, more uniform mesh, etc. The mesh surface is relatively flat, the structure is very strong, the overall performance is strong, and it has strong corrosion resistance and strong protective rib welded mesh strength. In order to make the steel wire mesh widely used in structural buildings, the width and length of the grid frame should be customized according to the size of the steel structure roof. The construction speed is fast and the quality is fully guaranteed. The self-drilling screws fix the steel wire mesh and the cable together.

The diameter of cold-rolled ribbed steel bar is usually between 4mm~8mm steel mesh. In order to step on it more reliably, considering that the general grid spacing is between 3cm~5cm, special specifications can be customized for your companies.

Raw materials can be divided into welded steel, cold-rolled ribbed steel bar welding, rolled and drawn cold-welded round steel, hot-rolled ribbed steel bar welding, ribbed steel bar welding is the most widely used, the steel bar, diameter, length and spacing, welding wire Mesh into steel horizontal welded steel mesh and about two custom welded steel.

What problems need to be paid attention to when processing the steel mesh of the steel mesh? After processing, the steel mesh of the construction should be flat, and the surface of the steel bar should not weaken the cross-section of the steel. The construction of the steel mesh should use grade 1 Φ8 or Φ6.5 round steel. Welding, gathering and adding in the steel bar processing plant.

Straighten with steel bars first, and then cut into steel bars. The size of the steel mesh shall be determined according to the spacing between the arches and the overlap level between the meshes. The construction of the steel mesh is made of low-carbon steel wire, and the stainless steel wire is cold-rolled with ribs. Steel bars or cold-rolled round bars are at right angles to the longitudinal and transverse directions.

It is formed by electric welding of the cross at intervals. Before the construction of the steel mesh and the processing of the steel reinforcement, the greasy, paint, cement, and floating skin that can be dropped with a hammer and rust on the surface of the steel must be cleaned. Selection of Φ6 steel bars.