How to use construction mesh?

Construction mesh is used in municipal construction: overpass bridge deck pavement, square concrete aerial, concrete pipe, fence, slope protection, etc.;

Water conservancy, electric power, coal: water conservancy equipment, power dam foundations, protective nets, etc.; construction meshes are used in other areas: flood control equipment, slope reinforcement, collapse protection, breeding, animal husbandry, etc.

The use of construction mesh is also very common. The architectural mesh can be used as a mesh for external wall insulation.

Fixing method of hot-dip galvanized steel mesh: the steel mesh is fixed with plastic shrink bolts. When fixing the steel mesh, the steel mesh should be nailed from the top layer along the corners. The steel wire mesh should be laid horizontally or vertically according to the size of the grid joint. When nailing the wire mesh, first disassemble one end of the wire mesh (at a distance of 50 mm) into an L angle to facilitate turning and overlapping. Use a steel wire with a diameter of not less than 1.5 mm to make a V-shaped clip, first fix the steel wire mesh, and then install the anchors according to the plum-shaped hole or needle.

The floor slab is made of cast-in-place reinforced concrete slabs, and pressed steel plates are laid on the steel beams on the floors as a permanent formwork. The upper iron uses steel welded mesh. The construction mesh is a construction mesh composed of low-carbon wire rod steel bars, which are cold-rolled and rectified, and are displayed at a certain interval by using a welded wire mesh equipment to distinguish the longitudinal and longitudinal steel bars, and all the interspersed points are resistance-welded together.