Cleaning method of glass fiber window screen

Cleaning method of glass fiber window screen:

The main function of the invisible window screen is to ventilate and prevent mosquitoes. It is not really invisible, but the yarn warp used is thinner than that of the traditional panel screen. After installation, it gives a looming illusion, and it has good light transmission performance. Toxic, tasteless, long service life and many other advantages.

The window screen is mainly to prevent mosquito bites, but if the window screen is not kept clean, not only will the mosquitoes not get in, but the air flow is also bad, which will easily cause poor indoor ventilation. Therefore, it is necessary to pay attention to the cleaning of the window screen for some temporary dust. Can be cleaned on both sides with wet cloth or sponge at any time. If you don’t use it for a long time and there is a lot of dust on the upper area, you can pull down the window screen, cover it with a layer of newspaper, and spray water upward with a small watering can until the newspaper is completely wet, and then peel off the newspaper after a while. The dust will cover the newspaper, and the cleaning effect will be obtained.

1.     If it is only dust, soak it in warm water for 1 hour, and it can be washed off with detergent. If it is fruit juice, it can be washed away with spinach juice.

2.     If it is detachable, put it directly in a large basin, put water and wash with detergent. Those that cannot be removed must be washed with a brush.

3.  Mix the flour with water to make a viscous paste on the window screens. After 30 minutes (the room temperature is about 20 degrees), rinse with water.

4.  You can use 84 disinfectant solution, according to 1:150 cold water preparation, it is required to completely soak in the solution, after 15 minutes, rinse with water and dry.

5.  First wash with vinegar, then wash with dish soap, and it will be clean soon.