How to bend welded wire mesh

In many cases, the use of mesh requires bending. There is more than one way of bending the welded mesh panel. The bending treatment can increase the aesthetics in actual use. There are several commonly used bending methods as follows.

1. Thirty-degree bending at the top, this method is just a single bend at the top, and the bending angle is thirty degrees from the vertical, so the line is directly called a thirty-degree bend.

2. Three times of bending, the vertical metal wire of the product is bent three times to form an angle, but the value direction welded mesh panel is still kept on the same horizontal plane before and after bending. The bending place can be the top, The middle part or both parts are bent, which is often referred to as triangular bending.

3. Reinforced bending, which is a product type with one step more processing on the basis of triangular bending. An additional horizontal welded mesh panel is welded at the three bends to fix and bend the vertical metal wire.

These are the specific methods that can be used to complete the bending work of the mesh very well. I hope that everyone will know what to do after reading it.